Testing to connect the SKXBEE in single PC.

To test the XBee modules, we can test the communication by using 1 PC only..Just open 2 X-CTU software and click on different com port..In this case, click on com port 10 & 11..


After that,click at moderm configuration and click read the check the version and address of the XBEE..Key in value "2222" at destination address low and "1111" at 16-bit source address for com port and 10 and vice versa for com port 11.


Click write for both com port the store the address at XBEE and this may take 30 seconds to complete..After the moderm is connected to each other, try the terminal bar to see the flow of communication..The blue colour represent the transmitted data while the red colour represent received data..If the communication testing between XBEE is completed, we can proceed to the next step which communication via microcontroller..